Intex Filter Cartridge

By · Wednesday, August 19th, 2009

Intex Filter Cartridge

Spring will soon be here and so will the annual task of opening your pool. Advance planning can make the job much easier. There is nothing worse than realizing your short bag of shock when you're in the midst of preparing the pool. So let's first make a list of chemicals you may need.

There will be different needs depending on the type of pool you own, so this list is general. Consult your pool pump and instructions for additional information.

Before running out to your local pool chemical supply, now it is time to check all hoses, clamps, skimmer baskets, gaskets and O-rings. If a party appears to need replacing, take it with you to the store of the pool. Much easier to match replacement parts if you have the old part with you.

Now that you've finished the easy part, it's time to go to work. The first thing needed is to make the cover. Get help for this, as you want to avoid the water up in the pool water. If you have a pool on land, divert water a hose. If you have an in ground pool you must use a sump pump to remove water from above.

To get a good siphon started, connect the hose to the faucet and put the other end of the hose into the top water. Turn the hose for a minute or so to fill it. Next crimp the hose a foot or two of distance of the key, and with the other hand, disconnect the hose from the faucet. Place the hose in a drain pipe down to download and then release the crimp. The water will reverse and begin to drain.

Once you have cleaned the water, use a leaf rake to remove as many leaves and branches as possible. Then weight off cover or springs. At this time some people positioned around the pool will help keep water out of coverage. Try to turn your deck as a blanket keeping the dirt in the middle then the top. You need to scrub the full and adequate coverage for the summer dry storage.

Now is the time to connect all the hoses from the pump. Remember lubricant plugs, fittings, valves and O-rings with petroleum jelly. Also be sure to remove any plug freezing were used to cover the openings in the hose. Most likely need to add water to the pool. It should be filled to the skimmer halfway point.

At this point must begin recirculating the water and check for leaks around the pump and hoses. Once your pool is free of leaks and dripping foam and debris floating as you can with your skimmer net. Open all the valves to flood the hoses and prime the pool pump. Most manufacturers recommend constantly recirculation of pool water for at least three days. Any dirt and debris on the sides and bottom of the pool should be washed off. Use the broom their attachment to the vacuum for this group.

After all waste is removed and the pool has been washing, check your filter for cleaning. Some pumps have removable filter, while others are back-red, as clean as directed. Once the filter is clean, you can download now super water as per the instructions of the manufacturer. If you start with green water, will have much more impact. It may take a few days to clean water recirculation. Once the water has cleared, test your water or take a sample to your pool supply store and have been analyzed. Adjust water as needed and maintain recirculation. All that's left to do now is to wait for hot water so you can start enjoying your pool.

Gregory Fort is a partner with the company Pool-Pockets, manufacturers of Pool-Pockets – Your pool toy storage solution. http://www.pool-pockets.com

[affmage source=”ebay” results=”12″]Intex Filter Cartridge[/affmage]
[affmage source=”amazon” results=”6″]Intex Filter Cartridge[/affmage]
[affmage source=”clickbank” results=”4″]Intex Filter Cartridge[/affmage]

Comments are closed.